A good tip that many experienced mechanics know is to mark the location of each vacuum line so that you don't install them backwards. Once you've located the correct part, disconnect the electrical harness that is attached to the canister purge solenoid. Locate this component and match it with your replacement part before removing. One of the vacuum lines runs to the fuel injector rail, while the other is attached to the EVAP canister located near the fuel cell. It will have an electrical harness and two vacuum lines attached. On most vehicles, this component is located on top of the engine, or near the rear of the fuel system. Step 2: Raise the hood and locate the canister purge solenoid. Because of this, the first thing that should be done before replacing this part is to disconnect the power supply by removing the positive and negative battery cables. The canister purge solenoid is connected to a power connection that supplies the device with electricity in order to trigger the solenoid on and off. Step 1: Disconnect the vehicle's battery.
0 Comments
Leave a Reply. |